I am already three grains below listed maximum. I have found over the years that most of my guns are a little more accurate just under full loads. I was actually thinking of bumping the loads up a grain to try something different.
I would like to get the trigger pull to around three pounds but Winchester really does not want anyone adjusting the trigger. I was able to cut the majority of the stuff off with a pocket knife but the hols are completly filled. Any ideas for a solvent for the sealer?
Thanks again for all of the input. Sometimes frustration takes over judgement when I run up against this type of issue. I like the balance of the rifle and have until next deer season to get it right so I am willing to try about anything.
